Home Auto Repair Honda VTX 1300 BA-2061-XX – BAK Installation Instructions

Honda VTX 1300 BA-2061-XX – BAK Installation Instructions

78

Download CAUTION! We strongly recommend that a qualified Honda Technician install this kit since the carburetor must be removed from the motorcycle. Please read all directions before starting. INCLUDED IN THE KIT: (1) Re-usable Performance Air Filter (1) Baron VTX 1300 BAK Backing Plate (1) Filter Raincoat (1) Baron VTX 1300 Jet Kit (1) Reed Valve Block-off Kit (2) ¼-28 x 1 13/ 16 ” Zinc Hex Bolts (2) Aluminum Filter Spacers (2) ¼” Lock Washers (3) M5x16 Flathead Screws (1) M5x10 Stainless Steel Socket Cap Screw (1) ¼” x 1-1/2″ Black Spacer (1) M6x60 Socket Cap Screw (1) M6 Fender Washer (1) Chrome BAK Cover TOOLS REQUIRED: Shop Manual 7/16″ Open-End Wrench 3, 4 & 5 mm Allen Wrenches #2 Phillips Screwdriver INSTRUCTIONS: 1. Remove fuel tank according to Honda service manual procedures. 3. Remove idle cable holder from back of stock air filter. ear of the new BAK backing plate just below the nylon nipple. Bracket should face outward and slightly down when BAK is mounted. provided in Jet Kit box. 6. Install Reed Valve Block-off Kit using the instructions provided with that kit. Installation of this kit is optional. p to use some masking tape to hold them in place. 8. Install new backing plate to carburetor and secure with three flat-head screws provided (blue Loctite is asher through the front of the backing plate in the hole nearest the idle cable holder and then through plastic spacer. Secure into stock bracket on the engine.