Home Auto Repair 2004 Ford F-150 Front Bumper REMOVAL AND INSTALLATION

2004 Ford F-150 Front Bumper REMOVAL AND INSTALLATION

163
Download 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-00. 2. If removing the upper front bumper, remove the headlights. For additional information, refer to Section 417-01. To remove individual parts, only carry out the listed steps: 3. To install, reverse the removal procedure. Item 3: Bolt Removal Note 1. Discard the 3 bolts after removal (install new bolts during installation) 2. Remove the LH bolt and grille stopper. 3. Remove the RH bolt and position aside the grille stopper. Item 10: Upper Front Bumper Removal Note 1. If equipped with wheel lip mouldings, remove the 4 nuts. 2. Remove the six pin-type fasteners. 3. Remove the 4 screws. 4. Position aside the splash shield. 5. Disconnect the 6 moulding clips. 6. Position aside the wheel lip mouldings. 7. Release the fascia retaining clips. Item 12: Fog Lamp Electrical Connector Removal Note 1. Detach the harness push pin from the fog lamp bracket. Item 13: Bumper Nut Removal Note 1. Discard the bumper nuts after removal (install new bumper nuts during installation). Item 15: Valance Panel Removal Note 1. If equipped, remove the fog lamps.