Download INSTALLATION STEPS 1) Decrease exhaust by eradicating the (6) rubber isolators. (See Rubber Isolator Removal Diagram.) 2) Take away the heats shields and trim to clear hitch mount plates. (See Warmth Shield Trimming photos.) three) Fishwire a 7/16-14 carriage bolt and CM-SP7 spacer via the entry hole and out the mounting gap in every frame rail as shown. (See Fishwire Technique.) four) Remove the (2) current bolts in every frame help bracket. 5) Chase the threads of the weld nuts utilizing a M10 x 1.50 tap. 6) Set up the heat shields, raise the exhaust into place and set up the (6) rubber isolators removed in Step 1. 7) Raise the hitch into place sandwiching a 7/sixteen flat washer between the hitch mount plate and frame rail on each sides on the location of the 7/16 carriage bolt put in in Step 3. Secure the hitch using the 7/sixteen hex flange nuts. eight) Install the M10-1.5 x 35mm hex flange bolts into the present weld nuts. 9) Torque all 7/sixteen hardware to 50 lb. ft. Torque all M10 hardware to 35 lb. ft.