Home Auto Repair 2004 Toyota 4Runner Sport HUB & STEERING KNUCKLE Removal Installation

2004 Toyota 4Runner Sport HUB & STEERING KNUCKLE Removal Installation

111
Download Removal 1. Raise and support vehicle. Remove front wheel. Remove shock absorber. See LOWER CONTROL ARM & BALL JOINT . Remove hub grease cap. Remove ABS speed sensor and wire harness clamp from steering knuckle. Remove brakeline bracket from steering knuckle. Remove the bolt and separate the brake tube bracket from the steering knuckle. Using Special Tool (09023-00100), disconnect the brake tube from the front disc brake caliper assembly. Remove the bolt and separate the brake tube bracket from the steering knuckle. Remove the 2 bolts and front disc brake caliper assembly. Remove rotor. 2. On 4WD models, using a screwdriver and a hammer, remove the front axle hub grease cap. Remove the cotter pin and a lock cap. Remove the front axle hub nut. On all models, remove the nut and separate the stabilizer link assembly from the steering knuckle. Remove the cotter pin. Using Special Tool (09628- 62011), separate the tie rod end sub-assembly from the steering knuckle.