Download Removal 1. Disconnect battery ground cable. Disconnect positive battery cable and wait one minute for the air bag diagnostic monitor (14B056) to deplete the air bag backup power supply. Refer to Section 01-20B. 2. Loosen main wiring connector bolt in engine compartment at LH side of dash panel (01610) and separate connectors. 3. Disconnect the radio-to-antenna wiring. Refer to Section 15-02. 4. Remove both RH and LH windshield side garnish mouldings (03598) . 5. Remove safety belt anchor bolts. Remove screws retaining both RH and LH front door scuff plates (13208) . Lift front door scuff plates and remove front door opening weatherstrips (20708) from body flanges. Scuff Plate, Front Door 6. Remove the RH and LH cowl side trim panels (02344) . 7. Remove the steering column. Refer to Section 11-04, Removal and Installation, Steering Column. 8. Remove one screw and A/C evaporator register duct (19B680) from under the steering column tube (3514) . 9. Loosen main wiring connector bolt at LH side of steering column opening and separate connectors.