Home Auto Repair 2000 Toyota Corolla CE Heating and Air Conditioning Control Assembly Removal and...

2000 Toyota Corolla CE Heating and Air Conditioning Control Assembly Removal and Installation

93
Download 12. REMOVE A/C CONTROL ASSEMBLY Remove the 2 screws and pull out the A/C control assembly, then disconnect the connector. NOTE: Be careful not to vent the mode control cable, when pull out the A/C control assembly. INSTALLATION 1. INSTALL A/C CONTROL ASSEMBLY a. Connect the connector. b. Pass the heater control cables as shown in the illustration. COMPONENTS REMOVAL 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. REMOVE COWL SIDE TRIMS REMOVE FRONT DOOR SCUFF PLATES REMOVE LOWER FINISH PANEL REMOVE LOWER INSERT PANEL REMOVE CENTER CLUSTER FINISH PANEL REMOVE HEATER TO RESISTOR NO.2 DUCT REMOVE LOWER PANEL REMOVE REAR CONSOLE BOX REMOVE SHIFTING HOLE BEZEL REMOVE FINISH LOWER CENTER PANEL 11. DISCONNECT HEATER CONTROL CABLE c. Install the 2 set screws. 2. CONNECT HEATER CONTROL CABLES a. Set Air inlet control lever at “RECIRC” position b. Set Temperature control dial at “MAX. COOL” position c. Set Mode control dial at “DEF” position Zoom d. Adjust air inlet control cable.