Home Auto Repair 2003-2004 MITSUBISHI LANCER EVOLUTION SPARCO HARNESS BAR INSTALLATION

2003-2004 MITSUBISHI LANCER EVOLUTION SPARCO HARNESS BAR INSTALLATION

74
Download INSTALLATION 1. Assemble the harness bar support rods as shown below using the provided heim joints and nuts. Leave at least ¼” of thread showing on each heim joint to allow for adjustment during installation. Do not fully tighten the nuts at this time. NOTE: The smaller heim joint has reverse thread. 2. On both sides of the vehicle’s interior, remove the plastic upper seat belt bolt cover and remove the upper bolt as shown here. The factory retaining washer needs to be removed so the factory bolt can be completely removed from the upper mount. NOTE: The factory retaining washer will be re- used in the installation process. 3. Assemble the upper mounting hardware as shown in this picture and bolt the assembly into vehicle. Do not fully tighten the bolt at this time. 4. Remove the factory lower harness bolt cover (rubber) and remove the bolt from the vehicle. Remove the factory retaining washer and remove the bolt from the harness mount. Assemble the lower hardware as shown in this picture. Bolt assembly into the vehicle.