Home Auto Repair 1999 Jeep Cherokee IGNITION SWITCH REMOVAL

1999 Jeep Cherokee IGNITION SWITCH REMOVAL

116
Download 1. Remove key cylinder. Refer to previous steps. 2. Remove lower steering column cover screws and remove cover. 3. Remove ignition switch mounting screw. Use tamper proof torx bit (Snap-OnĀ® SDMTR10 or equivalent) to remove the screw. 4. Using a small screwdriver, push on locking tab and remove switch from steering column. 5. Disconnect two electrical connectors at rear of ignition switch. INSTALLATION 1. 2. 3. 4. Before installing ignition switch, rotate the slot in the switch to the ON position. Connect two electrical connectors to rear of ignition switch. Make sure that locking tabs are fully seated into wiring connectors. Position switch to column and install tamper proof screw. Tighten screw to 3 N.m (26 in. lbs.). Install steering column lower cover.