Download 1. Disconnect battery ground cable (14301) if equipped with liftgate lamps. 2. Remove the two cover caps from the liftgate assist handle. 3. Remove the two liftgate assist handle screws and the liftgate assist handle. 4. If equipped, remove the liftgate lamps and housings. Refer to Section 17-02. 5. If equipped, pull out the plastic lock pins on each side of the liftgate glass latch cover and remove the liftgate glass latch cover. 6. Pull from the top center (nearest liftgate glass) of the liftgate door trim panel (46404) to remove. Installation To install, reverse the removal procedure. Tighten the liftgate pull handle screws to 3 Nm (26 lb-in).