Home Auto Repair 2006 Mazda 3 i WHEEL HUB, STEERING KNUCKLE REMOVAL/ INSTALLATION

2006 Mazda 3 i WHEEL HUB, STEERING KNUCKLE REMOVAL/ INSTALLATION

62
Download CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle. 1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, inspect the front wheel alignment and adjust it if necessary. (See FRONT WHEEL ALIGNMENT ). Fig. 3: Wheel Hub/Steering Knuckle Components & Torque Specification Fig. 4: Knocking Crimped Portion Of Locknut Outward Using Small Chisel And Hummer Fig. 6: Separating Shock Absorber From Wheel Hub, Steering Knuckle Component