Download Kit Part # 51/54-10322. Complete kit. Make sure you have all the components before you begin your installation. Complete stock intake. a. Remove two screws holding factory fresh air duct in place. b. Pull fresh air duct out of vehicle and save for later use a. Remove two screws holding top half of airbox in place. b. Loosen clamp holding factory tube in place. c. Unplug MAF Sensor Remove top half of factory airbox. Remove clamp holding top breather filter on factory tube. Remove clamps holding second breather from top of factory tube. Save elbow for later use. Remove clamps holding third breather filter from top of factory tube. Plug can be disconnected for ease of removal. Loosen clamp holding fourth breather down from top of tube with slotted screwdriver. Loosen clamp at turbo and Last breather tube. Pull factory tube out of vehicle. Pull off front grill near Passenger side fog lamp. Remove fog light from vehicle. Remove fitting from air pump hose and install provided breather filter. Install filter onto air pump and replace fog lamp and grill. Remove MAF Sensor from top half of air box.Using provided Gasket and (2) M4x.7×16 screws install MAF Sensor onto aFe intake tube.