Home Auto Repair 2001 Lincoln Town Car Instrument Panel REMOVAL AND INSTALLATION

2001 Lincoln Town Car Instrument Panel REMOVAL AND INSTALLATION

99
Download Removal 1. Depower the supplemental restraint system (SRS). For additional information, refer to Section 501-20B. 2. Open the glove compartment door and disconnect the isolator. 3. While pushing in on the 2 glove compartment door tabs, position the glove compartment downward. 4. Through the glove compartment opening, remove the instrument panel support brace bolt. 5. Close the glove compartment door. 6. Position the speed control servo aside. 1. Remove the nuts. 2. Position the speed control servo aside. 7. Disconnect the LH bulkhead connector. 1. Loosen the bolt. 2. Disconnect the LH bulkhead connector. 8. Unclip the LH bulkhead connector from the dash panel. 9. Remove the windshield washer reservoir. For additional information, refer to Section 501-16. 10. Disconnect the blower motor electrical connector. 11. Disconnect the A/C pressure cut-off switch electrical connector. 12. Disconnect the in-line wiring harness connector. 13. Disconnect the electronic automatic temperature control (EATC) variable blower motor controller electrical connector. 14. Remove the RH front wheel and tire assembly. For additional information, refer to Section 204-04. 15. Remove the fender splash shield bolts.