Download 1. Disconnect the battery ground cable (14301). 2. Partially drain the cooling system; refer to Section 303-03. 3. Remove the water bypass tube (8555); refer to Section 303-03. 4. Disconnect the fuel tube. 5. Disconnect the heater hose. 6. Remove the positive crankcase ventilation valve (PCV valve) (6A666) from the RH valve cover (6582). 7. Remove the main chassis vacuum supply tube. 8. Disconnect the powertrain control module grounds. 9. Disconnect the engine control sensor wiring (12A581) from the powertrain control module (PCM) (12A650). Remove the nut from the stud. 10. Remove the bolts and the ignition coil cover. 11. Disconnect the engine control sensor wiring from the four ignition coils (12029). 12. Remove the nuts and position the engine control sensor wiring out of the way. 13. Remove the four ignition coils. 14. Remove the cross-vehicle support. 15. Remove the valve cover. Remove the eight bolts and two studs from the RH valve cover. Remove the RH valve cover.