Home Auto Repair 1994 Lincoln Mark VIII Power Mirror REMOVAL AND INSTALLATION

1994 Lincoln Mark VIII Power Mirror REMOVAL AND INSTALLATION

46
Download Removal 1. Disconnect battery ground cable (14301) . 2. Remove front door trim panel . Refer to Section 01-05. 3. Remove outside rear view mirror inside mounting hole cover (17K709) from front door trim panel . 4. Disconnect outside rear view mirror assembly wiring connector and remove necessary wiring guides. 5. Remove plug button and remove the three mirror retaining nuts. Remove the outside rear view mirror while guiding the wiring and connector through the hole in the door. Installation 1. Install the outside rear view mirror assembly by routing the connector and wiring through the hole in the door and attach with three retaining nuts. Tighten to 4.5- 6.3 Nm (40-55 lb-in). Install plug button. 2. Connect mirror wiring connector and install wiring guides. 3. Install mirror outside rear view mirror inside mounting hole cover (snaps in). 4. Install front door trim panel . Refer to Section 01-05. 5. Connect battery ground cable. Glass, Outside Mirror Removal 1. Rotate outside rear view mirror glass to maximum upward travel. CAUTION: Use a piece of clean rag or similar material placed on the mirror shell to protect it from damage while removing the glass. 2. Insert a flat blade screwdriver between mirror shell and glass on bottom edge approximately one inch from inside corner at point A. 3. Place hand over outside rear view mirror glass to keep it from falling out and apply downward force on screwdriver until a snap is heard and glass is loose.