Home Auto Repair 2000 Ford Ranger FRONT SUSPENSION – 4WD TORSION BAR HUB & WHEEL...

2000 Ford Ranger FRONT SUSPENSION – 4WD TORSION BAR HUB & WHEEL BEARINGS (WITH PULSE VACUUM HUBLOCK)

31
Download CAUTION: DO NOT attempt to repair hub and wheel bearing assembly. Removal CAUTION: DO NOT remove hub lock assembly by prying on hub lock legs. This can crack or break hub locks, causing vacuum leaks. 1. Raise and support vehicle. Remove wheel and tire assembly. Remove brake caliper, and wire to underbody. Remove brake pads and caliper anchor plate. Remove rotor. Install Hub Removal Clips (205-404). See Fig. 4 . Install Hub Puller (205-405) over hub removal clips. See Fig. 5 . Align hub puller with 3 slots in hub lock. Tighten set screw finger tight. Connect slide hammer to hub puller. Using slide hammer, remove hub lock. 2. Remove and discard hub “O” ring. Remove brake rotor shield. Pull out axle shaft end slightly. Remove axle shaft circlip. Disconnect vacuum hose from hub assembly and remove it from frame. Disconnect anti-lock sensor connector, and remove wire from frame (if equipped). CAUTION: