Download WINDOW REGULATOR, GLASS, AND GUIDE COMPONENTS Caution: Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. Removal / Installation 1. Disconnect the negative battery cable. 2. Remove in the order shown in the figure. 3. Install in the reverse order of removal. Caution: Remove the door screen carefully so that it may be reused. Note : Raise the door glass about 19O mm (1.5 in) from fully-open position. Removal Note: Regulator handle Remove the regulator handle clip with a rag, as shown. Installation Note: Regulator handle Install the regulator handle as shown. Note: With door glass at fully-closed position. Adjustment Door glass Adjustment of the door glass (convertible top and detachable hard top) is made as follows: 1. Vertical adjustment of door glass Adjustment procedure Remove the weatherstrip, and check alignment with the door glass in the fully-closed position. (1) Loosen upper stop installation bolts (A). (2) Adjust by moving the upper stop up or down so that the upper edge of the door glass is in thecorrect position, and then tighten bolts (A). Note: When the door glass is raised, both glass stop must contact the upper stop simultaneously. Before an upper stop is moved for adjustment, lower the door glass slightly.