Home Auto Repair Honda UTS6, UTS6BI & UTS10BI Auto Start Installation Instructions

Honda UTS6, UTS6BI & UTS10BI Auto Start Installation Instructions

70
Download 1. Review the , a UTS Auto Begin Kit Elements List nd guarantee all components are included. 2. Remove the six (6) square screws 3. Remove the plastic plug from the top proper of the UTS. 4. Install the three/eight -inch pressure relief cable clamp and fasten it into place utilizing the locknut provided. 5. Feed the generator Auto Begin cable by means of the cable clamp. 6 outer jacket S . Prepare the Honda remote as follows: a. Remove approximately ” of the . b. journey off 1/4” of insulation from three of the jacketed conductors: black, white and green. c. Lower 2” of wire from remaining (purple) conductor and set aside 7. Connect the 6-place generator Start/Cease connector to the Auto Begin cable. See wiring diagram on the reverse aspect of this sheet for more details. 8. Join the 6-position connector to the printed circuit board as proven above, then tighten the Cable Clamp 9. Set up the , and fasten it in place with the sq. drive screws eliminated in step 2. UTS cover 11. On UTS, press “System Setup” button till “Gen Begin Mode” appears. Press arrow key to select “Auto.” 12. Press “System Setup” button until “Gen Start Relay Pos” appears. Press Arrow key to pick out “Normally Closed.” 13. Press “System Setup” button until “Gen Stop Relay Pos” appears. Press arrow key to select “Usually Closed.”