Home Auto Repair 2006 Land Rover Parking Brake Actuator Service Manual

2006 Land Rover Parking Brake Actuator Service Manual

82
Download 2006 Land Rover Parking Brake Actuator Service Manual – Removal 1. Using the Land Rover approved diagnostic system, drive the parking brake to the ‘mounting position’. 2. Isolate the parking brake electrical circuit. Remove fuse number 8 from the BJB. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. 3. Raise and support the vehicle. 4. Remove the rear wheels and tires. 5. Release the parking brake shoe adjustment. Remove the plug from the access hole in the brake disc. Using a suitable tool, rotate the brake shoe adjuster to release the adjustment. CAUTION: Do not allow the brake caliper to hang on the brake hose. 6. Reposition the RH rear brake caliper. Remove the 2 bolts. Using a suitable tie strap, support the brake caliper. 7. Remove the RH rear brake disc. Remove the screw. CAUTION: Do not allow the brake caliper to hang on the brake hose. 8. Reposition the LH rear brake caliper. Remove the 2 bolts. Using a suitable tie strap, support the brake caliper. 9. Remove the LH rear brake disc. Remove the screw. 10. Disconnect both parking brake cables from the wheel hubs. Fully loosen the nut. Release the cable from the lower arm. Disconnect the inner cable from the brake shoe 11. Release the LH parking brake cable. Remove the 2 bolts. Release the 3 wiring harness clips.