Home Auto Repair 1998 Jaguar Vanden Plas Starter Motor Service Manual

1998 Jaguar Vanden Plas Starter Motor Service Manual

109
Download 1998 Jaguar Vanden Plas Starter Motor Service Manual – Removal 1. Open the engine compartment and fit paintwork protection sheets. 2. Disconnect the battery ground cable. Remove the battery cover. 3. Place the vehicle on a ramp. 4. Working from below the vehicle, remove the power steering rack for access. 5. Disconnect the starter motor main terminal. Reposition the rubber boot from the main terminal. Remove the nut from the starter motor main terminal. Disconnect the main cable from the terminal. 6. Disconnect the starter motor solenoid terminal. Reposition the rubber boot from the terminal. Remove the nut from the solenoid terminal. Disconnect the cable from the terminal. 7. Remove the starter motor securing bolts. Remove the upper securing bolt. Preferably, use a short 13 mm spanner or a Snap On Half Moon spanner CMX1113 to initially loosen the bolt. (Refer to the next step). Remove the lower securing bolt. Carefully remove the starter motor. 8. The upper bolt may be removed (after loosening) using a 3/8′ square drive 13 mm socket, extensions and U.J as shown. Installation 1. Installation is the reverse of the removal procedure. Tighten the starter motor securing bolts to 35-48 Nm. 2. Refit the steering rack as detailed in Operation 57.10.01.