Home Auto Repair Audi A3 8PA Sportback Facelift Rear Lights Installation Instructions

Audi A3 8PA Sportback Facelift Rear Lights Installation Instructions

77

Download Coding NOTE: The installation has to be finished before activating the rear lights by using the coding adapter article-ID 37009. • After installation the facelift rear lights has to be activated • The coding dongle is just suitable for one vehicle. • Turn on the ignition and put the red OBD connector into your car‘s OBD connection. The OBD-Box is located in the driverside‘s footwell close to the upper cover. Leave the dongle connected for about 15 sec. to the OBD connection. After disconnecting the adapter the activation has been done. Installation instruction Please open the hatch as well as the service cover (image 1). Loose the screws of the outer rear lights and remove it (image 3). Integrate the delivered Plug & Play adapter (image 4) between the original connector coming from the vehicle and the new outer facelift rear light. Further you need to remove the cover of the hatch. Please loose the needed screws (image 5). Now you can gently pull the cover. Loose the screw of the inner rear lights and remove the connection. Integrate the delivered Plug & Play ad-apter between the original connector coming from the vehicle (image 6) and the new inner facelift rear light. The single looms of the inner adapters needs to be connect to the GRAY loom (PIN 3) of the licence plate illumination (image 7, 8, 9). Please remove about 10 cm of the coat. In order to achieve a proper connection we recommend solding the new wires. The installation has been finished.