Home Auto Repair Spoiler Installation Instructions for Suzuki Kizashi 2010-Up

Spoiler Installation Instructions for Suzuki Kizashi 2010-Up

87

Download Spoiler Installation Instructions for Suzuki Kizashi 2010-Up – Hardware: QTY 2 pan head bolts and washers and QTY 2 T-Straps. 1. Always pre fit to the vehicle prior to sanding or painting. 2. NOTE: the center hole is an air hole, “Vent” DO NOT FILL IN. 3. Place T-Straps in the two bolt holes on the spoiler, and position the spoiler on the car, make sure you can see the t-strap ends to tape. 4. Secure the T-straps using masking tape so that they stay on the vehicle as you remove the spoiler from the vehicle. 5. Using a 1/8 drill bit, drill through “pilot hole” of the T-Strap. 6. Remove the T-strap and drill a ¼ inch holes. 7. Prep and clean the surface well. It’s recommended to clean it at least (5) X’s ensuring a clean surface. 8. Mount the spoiler to the trunk lid using the ¼ inch Pan head bolts supplied in your hardware kit. Installation options: RKSport supplies hardware to; either mount the spoiler by using hardware and double sided tape, or just double sided tape. We used only double sided tape to install our spoiler and it’s physically glued to the car without drilling, however this is your choice and we will not be responsible if the surface isn’t cleaned and prepped correctly