Download CAUTION! We Strongly recommend that a qualified Honda Technician install this kit since the carburetors must be removed from the motorcycle. INCLUDED IN THE KIT: (4) Baron Main Jets (190, 195, 200, 210) (1) Baron Adjustable Needle (1) Baron Pilot Jet ( BP1 ) (2) E-Clips (1) Baron Slide Spring (1) Baron D-Tool TOOLS REQUIRED: Factory Service Manual Phillips Screwdriver Flat Screwdriver 8, 10 & 12mm sockets w/extension Needle-nose Pliers Wire Cutters THANK YOU FOR PURCHASING THE BARON VTX1300 JET KIT. INSTALLATION IS REASONABLY SIMPLE PROVIDING YOU FOLLOW THE INSTRUCTIONS BELOW IMPLICITLY. AS ALWAYS, PLEASE READ THE INSTRUCTIONS IN FULL PRIOR TO INSTALLING THE PRODUCT . IF YOU FEEL YOU DON’T UNDERSTAND IT, PLEASE CALL OUR TECH SUPPORT LINE, OR HAVE THE PRODUCT INSTALLED BY A COMPETENT TECHNICIAN. INSTRUCTIONS: 1. Remove fuel tank per service manual instructions. 2. Remove the air filter and backing plate. r from the top of the carburetor. Be careful here as the spring inside the assembly can pop out. embly or “slide”) with the needle & spacers e unter-clockwise while pushing down on it to compress astic nub on the inside of the holder that locks this spring in place.