Home Auto Repair PRIDE – CHMSL Wiring Harness Repositioning Range Rover 4.0/4.6

PRIDE – CHMSL Wiring Harness Repositioning Range Rover 4.0/4.6

40

Download PRIDE – CHMSL Wiring Harness Repositioning Range Rover 4.0/4.6 – PROCEDURE Disassembly 1. Disconnect the negative battery terminal. 2. Open upper tailgate. 3. Release load space lamp from the trim panel, disconnect the electrical connectors and remove the lamp. 4. Remove six Phillips screws securing the trim panel to the upper tailgate (illustration). 5. Release the 4 studs securing the trim panel to the upper tailgate. 6. Disconnect the stop lamp connector. 7. Remove trim piece. 8. Inspect the wires and repair if necessary Repair Cut an approximately two inch by one inch wide piece of masking tape and secure the wires away from the screw post as shown in the illustration. Installation 1. Reconnect stop lamp connector and secure the trim panel to the 4 studs. 2. Secure the trim panel to the upper tailgate using the 6 screws. 3. Reconnect the electrical connectors and secure the load space lamp to the trim panel. 4. Reconnect negative battery terminal.