Home Auto Repair ASX/Outlander Sport Front Corner Extension Installation Manual

ASX/Outlander Sport Front Corner Extension Installation Manual

62

Download ASX/Outlander Sport Front Corner Extension Installation Manual – 1) Clean and degrease the front corner extension mounting positions (hatched area in the drawing) using shop towel moistened with isopro-pyl alcohol or degreaser. 2) Remove the two clips securing the splash shield and front bumper shown in the drawing. 3) Install the speed nut to the lower clip mounting hole on the front bumper as shown in the drawing. 4) Cut out the LH and RH templates from the tem-plate . Align the LH template with the end of the corner rounding of a step on the front bumper and with the rear end of the bumper at the bottom of the vehicle as shown in the drawing, and attach the LH template on the bumper with adhesive tape. 5) Temporary install the front corner extension with the tapping screw and the speed nut (installed in 3)). There should be no gap between the rear end of the front corner extension and the splash shield. 6) Align the front corner extension with the LH tem-plate and temporarily fix the extension with adhesive tape. 7) Mark the upper mounting hole position at the rear of the front corner extension on the splash shield.