Home Auto Repair 1997 Isuzu Rodeo S Fuel Pump Pressure Test Repair Manual

1997 Isuzu Rodeo S Fuel Pump Pressure Test Repair Manual

55
Download 1997 Isuzu Rodeo S Fuel Pump Pressure Test Repair Manual – NOTE: 1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Install a fuel pressure gauge between fuel pressure regulator and fuel distributor pipe. See Fig. 1 . Bleed air from fuel line going to pressure gauge. 2. Unplug fuel pressure regulator Vacuum Switching Valve (VSV) connector on right side fender skirt. This is a 4-wire connector with Black and Blue wires in harness. PCM controls VSV to cut vacuum to fuel pressure regulator during hot engine starts. 3. Start engine and measure fuel pressure at idle. Disconnect fuel pressure regulator vacuum hose. Note fuel pressure at idle with vacuum hose disconnected (no vacuum). Fuel pressure should be 42 psi (3.0 kg/cm2 ). See FUEL PUMP PERFORMANCE . 4. If fuel pump pressure is low, check for fuel leaks, restrictions in intake side of fuel pump, leaking injectors, faulty pressure regulator or faulty fuel pump. If fuel pressure is high, check for restrictions in return line to tank or faulty pressure regulator. If pressure does not change when pressure regulator is disconnected, replace pressure regulator.