Home Auto Repair FORD FLARESIDE BEDLOCKER ELECTRIC RETRACTABLE TRUCK BED COVER INSTALLATION INSTRUCTIONS

FORD FLARESIDE BEDLOCKER ELECTRIC RETRACTABLE TRUCK BED COVER INSTALLATION INSTRUCTIONS

75

Download TOOLS REQUIRED FOR ASSEMBLY: 7/16″ wrench or socket 3/8″ wrench or socket #2 Phillips screwdriver Tape measure. DRAIN HOLE LOCATIONS: The Bedlocker is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet metal is not required. If drilling is necessary, be sure to check the underside of the truck bed for the best location. The holes should be located near the side and as far forward as possible. Use a drill bit suitable for sheet metal (such as a taper drill or step drill). Drill drain tube clearance holes at 3/4″ (19mm). This will need to be done before installing the cover. OPTIONAL WIRING HARNESS FOR DASHBOARD SWITCH: The BedLocker also offers an optional wire harness (part # BL1120) to manually operate the tonneau cover from inside the cab of your truck. This harness is designed to plug into the custom-built electronics control box. Simply run the wire to the cab and attach under the dash in a suitable location. STEP 1: REMOVE CONTENTS & PLYWOOD PACKAGING Remove the canister and top cover from the box. Remove components from inside the canister.