Home Auto Repair 2006 RIDGELINE AIR DEFLECTOR P/N 08P47-SJC-100 Installation Instruction

2006 RIDGELINE AIR DEFLECTOR P/N 08P47-SJC-100 Installation Instruction

74

Download TOOLS AND SUPPLIES REQUIRED Phillips screwdriver Tape measure Felt-tip pen Shop towel asking tape Clip remover Center bracket 2 Front brackets A 2 Front brackets B 2 Side brackets 6 Plastic grommets 6 Screws, 5 x 13 mm 2 Screws, 6 x 11 mm 7 Protective tapes Air deflector 2 Alcohol pads center stopper AII 28583 All 28583 (0502) 1. Using the front “H” emblem, locate the center of the hood. From the bottom of the hood, measure up 2 in. (52 mm), and clean the area where the center support will attach with one alcohol pad from the kit. 4. Turn over the rubber molding and locate the six square holes in the hood. Push one plastic grommet into each square hole. 5. Clean the front edge of the hood with the other alcohol pad from the kit. INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” NOTE: Be careful not to damage the body finish when you install the air deflector. This air deflector should be installed only when the ambient air temperature is above 60°F (15°C). 2. Remove the adhesive backing from the center stopper, and attach it to the hood at the marked location with the convex mark facing down. 3. Open the hood. Locate the outer four clips that attach the rubber molding. Remove the four clips from the rubber molding. 4120081H Clean the front edges.