Download How to Install Chrome Hood Deck Cover on ’05-07 Hummer H3 – Step 1: Clean surface of hood vent to remove any dirt, debris, oil, grease and wax. It is recommended to use rubbing alcohol. Note: The application surface must be warm. Minimum temperature of 10°C (50°F). Step 2: Remove the original part from the vehicle by lifting the front of the part up as shown in the above picture. (Note: Keep the original part.) Step 3: Determine the part placement by aligning the cover using the front tabs as a guide as shown in the above pictures. Step 4: Remove protective film from part. Step 5: Wipe area second time with a cloth using K-520 Primer Adhesion Promoter or Alcohol to remove all oils and waxes. Step 6: Peel the red backing off the tape located on the back of the hood deck cover. Step 7: Align carefully and press firmly to ensure all tape had come in contact with the cover. (NOTE: Once the tape comes in contact with the surface it will adhere immediately and is hard to remove.) Step 8: Bend rear tabs over on chrome cover to secure to the factory hood deck. Step 9: Insert hood deck with new chrome cover back into place by aligning the clips and firmly pressing it into place.