Home Auto Repair Honda CBR-929RR/954RR Exhaust System Manual Installation Instructions

Honda CBR-929RR/954RR Exhaust System Manual Installation Instructions

57

Download Before Installation: •Verify that all parts and accessories have been included (see list below). •Coat all exhaust pipe mating joints with anti-seize compound / lubricant (Finish Line Ti-Prep packet included). •Read and review these instructions, cautions, diagrams and images prior to starting any work. Installation Instructions: 1. Remove the lower fairing. Remove the rear turn signals. 2. Remove the existing exhaust system from the HTEV valve rearward, save the mounting bolts for reuse. Save the stock exhaust can mounting bolt and nut for the end can to the passenger foot-peg for reuse as well. 3. Install the supplied HTEV joint plate to the rear of HTEV valve (see photo 1) using the stock mounting bolts. Tighten per factory specifications. 4. Install the 2 Y-pipes to the joint plate, but do not install the supplied springs at this time. 5. Install the S-Bend to the two Y-pipes, but do not install the supplied springs at this time. 6. If you plan to keep the passenger foot-pegs, follow this step, otherwise, skip to step 8. Reassemble the right passenger foot-peg assembly in this order (from the sub-frame outwards): Spacer A, Stay Arm F, Spacer B, passenger foot-peg assembly (from step 7 above). Use the supplied 8x110mm bolts D (2x) to fasten to the sub-frame (reuse nuts). See figure 3 for details. Proceed to step 8. 7. If you plan to remove the passenger foot-peg assemblies, follow this step and ignore step 6 above. Use: Spacer A and place the Stay Arm F against it. Use the supplied 8x50mm bolts E (2x) to fasten to the sub-frame (reuse nuts). See figure 3 for details, but use only the hardware specified in this step. 8. Slide the TiForce end can into place.