Home Auto Repair 2015 Acura ILX Remote Control Engine Starter Installation

2015 Acura ILX Remote Control Engine Starter Installation

23

Download 2015 Acura ILX Remote Control Engine Starter Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Using isopropyl alcohol on a shop towel, clean the area where the ID label will attach. 3. Attach the blank ID label to the transmitter in the area as shown. 4. Using a plastic trim tool, remove the left and right lenses from the front roof module (two retaining tabs for each lens). 5. Remove the front roof module (two bolts, two clips, two retaining tabs, and unplug the vehicle connectors). 6. Remove the driver’s and passenger’s sunvisor holders by turning them 45° in the counterclockwise direction. 7. Remove the driver’s sunvisor: • Pivot the left sunvisor downward. • Wrap tape around the tip of flat-tip screwdriver. • Locate the slot in the bracket cover, and insert the flat-tip screwdriver into the slot. Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate it toward the door. NOTE: If the retaining tab did not stay pushed in, return the sunvisor to its original position and repeat this step. • Remove the driver’s sunvisor (unplug the vehicle connector). 8. Remove the driver’s A-pillar trim. • Pull away the driver’s door opening seal from the driver’s A-pillar trim. • Pull out on the driver’s A-pillar trim to release three clips. • To prevent clips from falling into the body panel area, carefully insert a shop towel between the driver’s A-pillar and the driver’s A-pillar trim.