Home Auto Repair 2003 Chevrolat Recon 3-Piece Cab Roof Light Installation

2003 Chevrolat Recon 3-Piece Cab Roof Light Installation

67

Download Drop Headliner • Remove sun visor assemblies and sun visor clamp (Torx 15 & 20 required) • Disengage passenger side grab handle. Insert small flat screwdriver to pull out covers/lock mechanism then pull out on handle until you feel it disengage. There is no need to remove handle from headliner. • Disengage DS and PS pillar covers. Pull out at top and away from pillar. Lower panel(s) down so you can drop headliner about 4-6”. • Remove overhead console. Remove front screw. Slide console forward a little and pull down in rear as is a clamp on each side that locks it into the overhead. • Disconnect On-Star speaker plug (if equipped) and map light plug. Remove console. At this point you should be able to pull the front part of the headliner down around the front of the windshield. It will only drop about 2” to 3” which should be enough to carefully reach the wires. Mount Lights The side marker lights require 2 holes and the center light 5 holes IIRC. Take your time and measure everything twice to make sure you don’t drill any extra holes. You only have one chance. Side lights: • On driver and passenger side, it is 4 1/4 inches from near edge of black rubber door rubber gasket to the near edge (side) of the roof marker lamp gasket • 4 1/8” from near edge of black rubber windshield gasket to front edge of the roof marker lamp gasket Center Light: