Home Auto Repair 2006-UP Chevy HHR Front Anti-Sway Bar Removal & Installation

2006-UP Chevy HHR Front Anti-Sway Bar Removal & Installation

87

Download KIT INSTALLATION 1. Open the hardware kit and remove all of the contents. Refer to the part list (Page 3) to verify that all parts are present. 2. Park the vehicle on a smooth, level concrete or seasoned asphalt surface and activate the parking brake. Block the FRONT wheels of the vehicle with appropriate wheel chocks; making sure the vehicle’s transmission is in 1 st gear (manual) or “Park” (automatic). 3. Using a properly rated floor jack, lift the REAR wheels of the vehicle off the ground. Place support stands, rated for the vehicle’s weight, and in the factory specified locations. Refer to the vehicle Owner’s Manual. Prior to lowering the vehicle onto the stands, make sure the supports will securely contact the chassis. 4. It is very important that the vehicle is properly supported during this installation to prevent personal injury and chassis damage! Make sure that the supports stands are properly placed prior to performing the following procedures. We DO NOT RECOMMEND using wheel ramps while performing this installation. 5. Slowly lower the vehicle onto the stands and, before placing the vehicle’s entire weight on them, again check that they properly and securely contact the chassis as described above. Check for possible interference with any lines, wires, cables, or other easily damaged components. 6. Loosen the bottom end links from the ends of the factory Anti-Sway Bar and remove all hardware and put aside.