Home Auto Repair 2011 Ford F250 Super Duty Installation Instructions Suspension Lift

2011 Ford F250 Super Duty Installation Instructions Suspension Lift

84
Download Front Installation: 1. With the vehicle on flat level ground, set the emergency brake, & block the rear tires. Raise the front of the vehicle & support securely using jack stands. 2. While supporting the front axle with a floor jack, remove the front tires / wheels. 3. Disconnect the front sway bar from the frame & install the new Skyjacker sway bar lowering brackets using the 7/16″ x 1 1/2″ fine thread bolts, washers, nuts, & OEM hardware. (See Photo # 1) 4. Remove the retaining clip from the upper brake line bracket & remove the bracket from the frame. Disconnect the 4WD actuator line from the upper frame. 5. Disconnect the steering stabilizer from the frame bracket & remove the bracket from the frame. Disconnect the drag link from the pitman arm & disconnect the track bar from the track bar bracket using a 1 3/16” socket. (See Photo # 2) 6. Remove the front shocks & lower the axle so the coil springs can be removed. (See Photo # 3) Note: Be sure to retain the upper rubber isolator pads, they will be used with the new Skyjacker coil springs. 7.