Home Auto Repair Honda Valkyrie 322/S322 Saddlebags Manual Installation Instructions

Honda Valkyrie 322/S322 Saddlebags Manual Installation Instructions

76

Download SADDLEBAG INSTALLATION 1. Refer to Figure 1. 2. Remove forward fender mounting bolt on right side and discard 3. Install 10mm x 56mm Short Hex Spool-Bolt Assembly and a 10mm x 5mm Aluminum Spacer on to rear fender. Information: Do not over tighten bolts 4. Remove rear fender mounting bolt on right side and discard. 5. Install 8mm x 65mm Short Hex Spool-Bolt Assembly and a 8mm Aluminum Spacer on to rear fender. 6. Repeat procedure on opposite side. 7. Mount saddlebags over spools on fender brace and secure with clips retained inside bags. 8. Inspect each clip to verify each clip is properly seated in retaining groove. See View “A”. Information: Bags will be easier to mount and remove if a small amount of silicone lubrication is applied to rubber mounting points. SADDLEBAG CARE INSTRUCTIONS • Do not exceed 20 lbs. per saddlebag this includes sitting or standing on bags, it is a common occurrence for a non-rider to attempt to sit on bags, this also may void warranty. • Periodically, apply a small amount of silicone lubrication to rubber mounting points. Saddlebags will be easier to mount and remove. • Remove grease, oil or mud with mild detergent and water. For fast touch-up, Windex or Turtle Wax F-21 will restore original luster. The use of any other chemicals may discolor the saddlebags.