Home Auto Repair GMC Yukon Denali Rear Mud Guard Installation Instructions

GMC Yukon Denali Rear Mud Guard Installation Instructions

72

Download Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. NOTE: It may be necessary to remove the wheels depending on the tools being used for installation. 1. Clean and degrease the mud guard location area on the fender before installation. 2. Remove existing fastener from location A and plastic fastener from location C (Figure 1). 3. Install mud guard to rear fender with existing fastener at location A (Figure 1). Check fit and parallel and adjust accordingly before tightening. 4. Install a u-clip, #10 screw and washer at location C. 5. Using mud guard as a template, mark and drill 1/8” holes at locations B and D. 6. Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip placed on the backside of fender liner (Figure 2). 7. Install #10 screw and washer at location B, thru mud guard, fender and into a U-clip placed on the backside of fender. PAINTING INSTRUCTIONS 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. 2. Sand painting surface with 320 grit sand paper. 3. Apply a coating of flexible primer-adhesion promoter. 4. Apply a flexible paint as directed by the paint manufacturer. PAINT PROTECTION FILM INSTALLATION INSTRUCTIONS 1. Position mud guard on fender to indicate placement location of paint protection film. 2. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry.