Home Auto Repair 2012 Honda Fit Clear Door Edge Film Installation Instructions

2012 Honda Fit Clear Door Edge Film Installation Instructions

77

Download Installing the Front Door Edge Film 1. Open the left front door. Using an alcohol swab, thoroughly clean the area where the left front door edge film will attach. 2. Close the left front door. Using a spray bottle with 3M protective tape application solution, spray the area where the left front door edge film will attach. NOTE: Do not spray the inside surface of the door. 3. Open the left front door again. Peel back about 50 mm (2 in.) of adhesive backing from the left front door edge film. Align the V-notch in the door edge film with the end of the character line on the upper part of the front door. 4. Continue to remove the adhesive backing while you align the center line on the door edge film with the edge of the door. 5. Insert the applicator into the soft sleeve. Starting in the middle of the door edge film and working outward, use the applicator to smooth out any bubbles in the film. To avoid lifting the film, move the applicator in only one direction. 6. When you are satisfied that the door edge film is firmly attached to the door, slowly remove the outer protective film. 7. Starting in the middle of the door edge film and working outward, fold the left front door edge film around the door edge using your fingers. Move your fingers in one direction. Attach the film over the seam sealant. Do not trim or damage the seam sealant. 8. Using a lint-free shop towel, wipe up the liquid from the front door edge film. Allow the front door edge film to dry thoroughly. 9. Repeat steps 1 through 8 to install the door edge film on the right front door.