Home Auto Repair 2010 Honda Fit Door Visors Installation Instructions

2010 Honda Fit Door Visors Installation Instructions

71

Download Installing the Front Door Visor 1. Fully open the driver’s window. 2. Install two brackets C on the left front door visor using two clips. Check each bracket’s shape and stamp mark, and install them in the correct positions.  3. Peel back approximately 1-1½ to 2 inches of adhesive backing from each adhesive tape, and tape the ends to the front surface of the left front door visor. 4. Using isopropyl alcohol, clean the door sash on the driver’s door where the left front door visor will attach. Allow the alcohol to dry. 5. Install bracket A between the door sash and the run channel in the position shown. 6. Temporarily install the left front door visor on the door sash using the two brackets C you installed on the left front door visor. 7. Push the left front door visor forward and up, and check that it aligns with the contour of the door sash. There should be no clearance between the brackets and the door sash. 8. Insert bracket E between the door frame and the door sash, and attach the door visor to bracket E using one clip. Verify the shape and the identification mark stamped on the bracket. 9. Adjust bracket A up or down until the hole in the bracket lines up with the hole in the door visor, and install a clip. 10. While holding the door visor up firmly and back against the rear edge, remove the adhesive backings. Use your finger to push up each bracket C so there is no gap between the brackets and the door sash. 11. Using a soft towel, press and hold the door visor against the door sash for 30 seconds.