Download 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Turn the knob clockwise, release the one retaining tab, and remove the driver’s dashboard under cover. 4. Remove the driver’s dashboard lower cover: • Remove the fuse lid (four retaining tabs), and open the pocket. • Remove the two self-tapping screws. • Gently pull out on the driver’s dashboard lower cover to release the eight clips, unplug the vehicle connector, and remove the lower cover. 5. Remove the passenger’s dashboard under cover (release the three retaining tabs and two pins). 6. Open the lid. Remove the dashboard pocket (one self-tapping screw, and pull out to release the two clips and three retaining tabs). 7. Remove the two self-tapping screws that fasten the heater control panel to the instrument panel. 8. Pull the heater control panel out toward you to release the four clips. Unplug the vehicle connector, and remove the heater control panel. 9. Remove the dashboard center lower cover. • Remove the two clips and five self-tapping screws, and pull the cover out toward you to release the three clips and two tabs. • Unplug the vehicle 2-pin connector from the accessory socket and remove the cover. 10. Open the lid on the accessory socket. Using a shop towel around a flat-tip screwdriver, gently pry on the socket, and remove the case. 11. Slide the ring into the hole in the cover box. 12. Align the socket locating tab with the cutout in the ring, and slide the cigarette lighter socket into the ring.