Home Auto Repair 2002-2003 Honda Civic Si Fog Lights Installation Instructions

2002-2003 Honda Civic Si Fog Lights Installation Instructions

94

Download INSTALLATION 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. 3. Remove the front bumper. • Remove the four clips from the top of the bumper. • Remove the six clips and two self-tapping screws from the bottom of the bumper. • Remove the two self-tapping screws from both ends of the bumper. • Pull out on both ends of the bumper to release the clips, then pull the bumper forward enough that you can reach behind it and disconnect the side marker lights. 4. Using scissors, cut out template A, and place it on the bumper grille by aligning the upper edge with the left upper edge of the bumper grille as shown. Tape the template. Using a pushpin, mark the bumper grille as indicated on the template. 5. Cut out template B, and tape it onto the bumper grille by aligning the lower edge with the left lower edge of the bumper grille as shown. Using a pushpin, mark the bumper grille as indicated on the template. 6. Cut out template C, and tape it onto the front bumper by aligning the inner edge with the left edge of the bumper grille as shown. Mark the bumper grille as indicated on the template. 7. Remove templates A, B, and C. While wearing eye protection, drill a 10 mm hole through each of the three marks. First drill with a 5 mm bit, then finish with a 10 mm bit.