Home Auto Repair 2012 Honda Civic Automatic Day/Night Mirror Installation

2012 Honda Civic Automatic Day/Night Mirror Installation

62

Download 1. Disconnect the negative cable from the battery. If the vehicle is equipped with map lights, go to step 2, otherwise go to step 3. 2. Remove the left and right lenses from the map light console (four retaining tabs for each lens). Remove the two bolts. With Moonroof • Remove the map light console. Then unplug three vehicle connectors, and remove the switch (four retaining tabs). Without Moonroof and With Hands Free Link • Remove the map light console (unplug two vehicle connectors). Without Moonroof and Hands Free Link • Remove the map light console (unplug the vehicle connector). 3. Remove the driver’s and passenger’s sunvisor holders. 4. Remove the cover (two retaining tabs). 5. While holding down the hook as shown, remove the rearview mirror from the mirror mount. 6. Wrap the tip of a flat-tip screwdriver with tape. Locate the slot in the bracket cover, and insert the flat-tip screwdriver into the slot. Push the hook with the screwdriver. 7. While pushing in on the hook, rotate the driver’s sunvisor backward about 45°. Make sure the hook slides into the bracket cover. NOTE: If the hook did not stay pushed in, return the driver’s sunvisor to its original position and repeat steps 6 and 7. 8. Remove the driver’s sunvisor. 9. Pull the driver’s door opening seal away from the A-pillar. 10. Pull out the driver’s A-pillar trim to release the clips. 11. Put a shop towel in the opening between the driver’s A-pillar trim and the dashboard to catch any A-pillar clips that drop