Home Auto Repair 2012 Honda Accord Door Sill Trim Installation Instructions

2012 Honda Accord Door Sill Trim Installation Instructions

105

Download Installing the Door Sill Trim NOTE: • Be careful not to damage the paint finish. • This kit should be installed only if the ambient air temperature is 15°C (60°F) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Please advise the customer 1. Open the left door. Measure and attach a piece of masking tape to the left side step trim. 2. Align the front edge of the left door sill plate to the masking tape attached in step 1, then press on the left door sill plate to fit it to the left side step trim. 3. Using an alcohol swab, thoroughly clean the left side step trim where the door sill trim will attach. 4. Attach pieces of masking tape to the ends of the adhesive backings as shown. Peel back the adhesive backings partway and temporarily attach them to the outer surface of the left door sill plate. Remove the remaining adhesive backings. NOTE: To verify that you have the left door sill plate, make sure that the logo is on the rear of the plate, and will face the outside of the vehicle. 5. Align the left door sill plate to the masking tape, then push to fit the left door sill plate to the left side step trim. 6. While applying light pressure against the left door sill plate, carefully remove the taped adhesive backings in the order shown. Using the palm of your hand, firmly press the left door sill plate to the left side step trim. 7. Remove the masking tape. 8. Repeat steps 1 through 7 on the right side of the vehicle.