Home Auto Repair 2011 Honda CRV Moonroof Visor Installation Instructions

2011 Honda CRV Moonroof Visor Installation Instructions

69

Download INSTALLATION 1. Clean and wax the roof area to be covered with a high-quality paste wax. 2. Open the moonroof. 3. Roll up two shop towels, and insert them between the roof panel and air deflector to lower the air deflector. Take care not to damage the air deflector. 4. At the left front corner of the moonroof opening, locate the front moonroof guide rail screw. From the guide rail screw, place a scale directly outboard from the screw as shown, and mark the edge of the roof with a felt-tip pen. 5. Using isopropyl alcohol on a shop towel, clean the roof area and the inside edge of the moonroof opening at the mark. 6. Remove the adhesive backing from one protective tape. Starting at the bottom edge, wrap the protective tape around the lip of the moonroof opening at the center of the mark; continue upward with the tape around the top of the roof panel. 7. Repeat steps 4 thru 6 to install the protective tape on the right side of the moonroof opening. Remove the marks you made using isopropyl alcohol on a shop towel. 8. At the front of the moonroof opening, locate the third weld mark from each end. 9. Using isopropyl alcohol on a shop towel, clean the third weld mark where the protective tape will be applied. 10. Remove the adhesive backing from one of the protective tapes. Starting at the bottom edge of the tape, wrap the protective tape around the lip of the moonroof opening to cover one of the located weld marks.