Home Auto Repair 2005 Honda Accord Outside Temperature Gauge Installation

2005 Honda Accord Outside Temperature Gauge Installation

69

Download Installation 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. Routing the Sensor Harness 3. Open the hood. Remove the radiator cover (ten clips and four retaining tabs). 4. Release the three retaining tabs of the hood lock cover, and pull the hood lock cover. 5. Remove the air duct cover (two clips), then remove the air duct. 6. Remove the relay box (two bolts), and remove the bolt that fastens the air cleaner housing cover. 7. Remove the pin from the clip, and measure and cut off the pins in the area shown. 8. Attach the sensor assembly to the stay on the bumper beam using two clips and two pins. 9. Route the sensor harness 2-pin connector through the front bulkhead along the vehicle harness. 10. Pull the hood lock cover, and route the sensor harness 2-pin connector toward the center of the vehicle along the vehicle harness. Plug the sensor harness 2-pin connector into the sensor 2-pin connector. 11. Push the sensor harness clip into the hole on the sensor bracket. 12. Pull the hood lock cover, and secure the sensor harness to the vehicle harness with five wire ties in the areas shown. 13. Near the battery, continue routing the sensor harness along the vehicle harness, and secure it to the vehicle harness with four wire ties. 14. Lift the air cleaner housing cover upward, and route the sensor harness toward the rear, along the vehicle harness