Home Auto Repair 2011 Cadillac CTS Exhaust Tip & Rear Valance Mesh Accent Kit

2011 Cadillac CTS Exhaust Tip & Rear Valance Mesh Accent Kit

77

Download 2011 Cadillac CTS Coupe EGX Exhaust Tip & Rear Valance Mesh Accent Kit 1. Remove the plastic push fasteners from the front edge of the rear wheel archs (three each side) by lifting up on the center of the push pin (as shown) then pull the entire pin straight out of the mounting hole. 2. Remove the 7mm bex bolt at the bottom edge of the rear wheel arch insert. 3. Remove the plastic push fasteners (one each side, just behind the tires) from the rear inside surface of the wheel arch. 4. Remove the factory 7mm hex bolts from the upper forward portions of the factory wheel arches (one each side). 5. Pull the rear wheel arch plastic shields out from the rear wheel wells for rear bumper cover hardware access. 6. Once the inner wheel liners are out of the way, remove the 7mm hex screws attaching the top corners of the bumper cover (one each side). 7. Disconnect the electrical connector prior to bumper cover re-moval. 8. Remove the lower two (2) factory push fasteners from the bottom of the bumper cover. 9. Pull the sides of the rear bumper cover straight out to release it from the mounting channel. 10. Use a flat blade screwdriver to push down on the mounting tabs across the top of the bumper cover. 11. Pull the bumper cover free from the back of the vehicle. 12. Disconnect the electrical connectors from the bumper cover mounted back up sensors. 13. Remove the factory plastic push fasteners from the bottom of the bumper cover (one per side)