Home Auto Repair 2013 Honda CRV Door Visors Installation Instructions

2013 Honda CRV Door Visors Installation Instructions

78

Download Installing the Front Door Visor 1. Install one bracket B to the left front door visor with one clip as shown. Be sure the bracket is installed properly, once the clip is installed it connot be removed. 2. Fully open the left front door glass. Pull down the door glass run channel in the areas shown. 3. Install two brackets A between the door sash and the glass run channel at the measurements shown. Seat the glass run channel properly around the brackets. 4. Using isopropyl alcohol on a shop towel, thoroughly clean the door sash where the left front door visor will attach. 5. Peel back approximately 1½ to 2 inches of adhesive backing from each adhesive tape, and tape the ends to the front surface of the left front door visor with masking tape. 6. Position the left front door visor onto the left front door by inserting bracket B between the door mirror base and glass run channel as shown. 7. Align the clip holes in the left front door visor with the bracket holes, and install the clips while pushing up on each bracket A. There should be no clearance between the brackets and the door sash. NOTE: Be sure the bracket and the door visor are aligned properly. Once the clip is installed, it cannot be reused. 8. Adjust the end gap of the left front door visor as shown. 9. While applying light pressure against the left front door visor, carefully remove the adhesive backings in the order shown. Use your finger to push up each bracket so there is no gap between the bracket and the door sash. 10. Using a soft towel, press and hold the left front door visor against the door sash for 30 seconds.