Download Installation NOTE: • Be careful not to damage the roof and other finished surfaces of the body when installing the roof box. • The maximum load capacity for this product is 110 lb (50 kg); approximate product weight is 29 lb (13 kg). • Do not allow the combined weight of the accessory and cargo to exceed the carrying capacity of the roof rack. • Honda roof racks or crossbars are required to install the roof box. 1. Open the roof box. Attach an adhesive seal over the unused mounting holes along the bottom of the box. The seals will help prevent water from entering the roof box. 2. Using isopropyl alcohol on a shop towel, clean four brackets B where the small pads will attach. Remove the adhesive backings from the small pads and attach them to the brackets B. 3. Using isopropyl alcohol on a shop towel, clean four plates where the large pads will attach. Remove the adhesive backings from the large pads and attach them to the plates. 4. Under the roof box, insert a bolt through bracket B, through the plate, and into the predrilled hole in the bottom of the roof box. 5. Fit bracket A over the threads of the bolt where it protrudes through the roof box. Install a washer over the threads, and loosely install a knob. Install a second bolt the same way. • Install bracket A so that the right and left strap eyelets are positioned directly across from each other. • Install bracket B with the cutout facing the outside. 6. With the help of an assistant, carefully place the box on the crossbars. Be aware of the hardware hanging from the bottom of the box.