Home Auto Repair 2013 Honda Fit Ambient Lights Installation Instructions

2013 Honda Fit Ambient Lights Installation Instructions

115

Download Installation 1. Make sure you have the anti-theft code for the radio and navigation system (if equipped), then write down the radio presets. 2. Disconnect the negative cable from the battery. 3. Under the dashoard on the left side of the vehicle, turn the knob on the driver’s dashboard under cover counterclockwise. Remove the under cover (one clip and two tabs). If equipped, release the harness clip and unplug the vehicle connector. 4. Remove the fuse access panel (two clips, five tabs, and two hooks). If equipped with fog lights, unplug the vehicle 5-pin connector and unclip the wire tie. 5. Remove the passenger’s dashboard under cover (three clips and two tabs). 6. Using isopropyl alcohol, clean the fuse case where the fuse label will attach. 7. Attach the fuse label (2A AMBIENT LIGHT) to the fuse case on the ambient light harness. 8. Without accessory fog lights: Unplug the vehicle 13-pin connector from the mirror switch, and plug it into the ambient light harness 13-pin connector. Plug the ambient light harness 13-pin connector into the mirror switch. Go to step 10. 9. With accessory fog lights: Unplug the vehicle 13-pin connector from the fog light harness, and plug it to the ambient light harness 13-pin connector. Plug the other ambient light harness 13-pin connector into the fog light harness 13-pin connector. 10. Using one wire tie, secure the excess ambient light harness and connector to the vehicle harness.