Home Auto Repair 2009 Honda Civic XM Radio System Installation Instructions

2009 Honda Civic XM Radio System Installation Instructions

72

Download Installation 1. Make sure you have the anti-theft codes for the audio and navigation system (if equipped), then write down the audio presets. 2. Disconnect the negative cable from the battery. 3. Remove the passenger’s dashboard under cover (four clips and two pins). 4. Remove the two bolts under the glove box. 5. Open and remove the glove box (two stoppers). 6. Remove the driver’s dashboard lower cover (eight clips). 7. Remove the inside cover from the front console pocket (two tabs). 8. Lower the tilt lever, then pull the steering wheel toward you. 9. To protect the dashboard area, put shop towels over the steering wheel and shift lever. 10. Apply masking tape to the instrument panel as shown, and remove the meter panel (one self-tapping screw, and 11 clips, and unplug the vehicle connectors). 11. Apply masking tape to the instrument panel as shown. Remove the center panel (two bolts, 11 clips, and aspirator hose, and unplug the vehicle connectors). 12. Pull the weatherstrip off in the area shown. 13. Push the clip into the vehicle side by striking the top of the right front pillar trim in the part marked as “SIDE CURTAIN AIRBAG” with the rubber mallet perpendicularly to the vehicle. Then, remove the clip. 14. Pull the weatherstrip off in the area shown. And remove the right front pillar trim (two clips). 15. Remove the cap from the right sunvisor (four retaining tabs).