Home Auto Repair 2012 Honda Civic Door Visors Installation Instructions

2012 Honda Civic Door Visors Installation Instructions

72

Download INSTALLATION NOTE: • Visors may not be legal in all states. Please check the laws of your state. • These instructions show the left door visors being installed. The same procedure applies to installing the right door visors. • Be careful not to damage the body paint finish and glass run channels when installing the door visors. • Handle the door visors with care. They are not designed to absorb shock or impact. • This door visors kit should be installed only if the ambient air temperature is 15°C (60°F) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Please advise the customer. Installing the Front Door Visors 1. Fully open the driver’s window. Pull down the glass run channel in the areas shown. 2. Install two brackets between the door sash and the glass run channel at the measurements shown. Seat the glass run channel properly around the brackets. 3. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the left front door visor will attach. 4. Adjust the position of the left seal B so there is equal spacing on both sides. Remove the adhesive backing from the left seal B, and attach it to the front lower channel. 5. Remove the adhesive backing from the seal A, and attach it to the door sash in the area shown. 6. Peel back about 25 to 40 mm (1.0 to 1.6 in.) of adhesive backing from each adhesive tape, and tape the ends to the front surface of the left front door visor. Remove the other adhesive backing.