Home Auto Repair 2012 Honda Civic Cargo Net Installation Instructions

2012 Honda Civic Cargo Net Installation Instructions

113

Download Installation 1. Install a bolt into each anchor A, and install a self-tapping screw into each anchor B. 2. Open the trunk lid. Remove the four clips from the trunk side lining. 3. While wearing eye protection, enlarge the two clip holes shown to 9 mm. Remove any burrs, and apply touch-up paint to each hole. To prevent drilling through the inner panel, wrap tape around the drill bit 10 mm (0.4 in.) away from the tip. Installing the Rivet Nuts 4. Pull off the weatherstrip in the areas shown, and move the trunk side lining out of your way. 5. Install two rivet nuts in the 9 mm holes you enlarged, as described in the following steps. 6. Screw the rivet nut onto the mandrel of the tool as shown. 7. Insert the rivet nut into the hole in the trunk side panel, and insert the hex wrench into the tool. 8. While holding the tool with the hex wrench, turn the open end wrench clockwise to install the rivet nut to the trunk side panel. 9. Remove the tool from the rivet nut by turning the hex wrench counterclockwise. 10. Reinstall the trunk side linings and the weatherstrip. 10. Reinstall the trunk side linings and the weatherstrip. 11. Reinstall the two clips removed in step 2. 12. Install two bolts/anchors A into the rivet nuts. 13. Pull the levers to fold the rear seat-back forward. 14. Remove the trunk floor mat (one clip). 15. Attach template R to the trunk right side lining as shown. 16. Put pieces of tape underneath the two marks on template R as shown.